Our Rope Gripper Control Unit can be installed on any controller and works with any Rope Gripper. This unit is designed to stop the car from ascending/descending overspeed and unintended movement detection.
Features
- On-board LCD diagnostics and setup
- protection against unintended car movement
- Built-in hardware redundancy
- Encoder feedback
- Manual reset procedure when triggered by an actual fault
- Works with positive or negative logic
- Using universal inputs and/or relays with the corresponding voltages of any controller
- Easy to wire, simple to install
- Using minimal amount of signals necessary
- Can be altered to meet specific requirements
Specification
- ASME A17.1
- CSA B44
| Rope Gripper Flyer | Download |
